MetalworkingFun Forum › Machining › General Metalworking Discussion v
Scrap yard find

Thread Modes
Scrap yard find
chucketn Offline
Junior
****
Posts: 375
Threads: 53
Joined: Jun 2013
Location: Jonesborough, TN
#9
05-29-2014, 10:04 AM
I think the short drills are spotting drills. Can anyone post a picture of a spotting drill, jobber length, and regular drill bit so I can get an idea of length, please?
What is the attack angle on a spotting drill?

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Scrap yard find - by chucketn - 05-28-2014, 07:57 AM
RE: Scrap yard find - by TomG - 05-28-2014, 04:54 PM
RE: Scrap yard find - by EdK - 05-28-2014, 05:01 PM
RE: Scrap yard find - by chucketn - 05-29-2014, 08:54 AM
RE: Scrap yard find - by chucketn - 05-28-2014, 06:35 PM
RE: Scrap yard find - by TomG - 05-29-2014, 09:42 AM
RE: Scrap yard find - by Highpower - 05-29-2014, 12:28 PM
RE: Scrap yard find - by Mayhem - 05-29-2014, 09:45 AM
RE: Scrap yard find - by chucketn - 05-29-2014, 09:55 AM
RE: Scrap yard find - by chucketn - 05-29-2014, 10:04 AM
RE: Scrap yard find - by EdK - 05-29-2014, 11:50 AM
RE: Scrap yard find - by Mayhem - 05-29-2014, 10:09 AM
RE: Scrap yard find - by EdK - 05-29-2014, 11:46 AM
RE: Scrap yard find - by TomG - 05-29-2014, 10:47 AM
RE: Scrap yard find - by PixMan - 05-29-2014, 04:58 PM
RE: Scrap yard find - by Mayhem - 05-29-2014, 07:20 PM
RE: Scrap yard find - by EdK - 05-29-2014, 08:08 PM



Users browsing this thread: 1 Guest(s)