Lathe Cross Slide Problem

[EdK]

(05-28-2014, 07:10 PM)PixMan Wrote: I'm confused about that, Ed, because you had given me a dimension of 0.926" from the flat bottom of the nut to the thread center line. That's exactly what I made it. I assumed you had already figured out the dimension when you put it on the print.

Ken,

I think in one of my posts I stated I had added about .020" to the dimension so I could tweak the height by either skimming or shimming. I'm not that skilled in these types of measurements so I thought it best to add a bit to the dimension for tweaking after I figured out how to make the measurement accurately. I'll figure it out. I just need to take the time to think it through.

Thanks Ken.

Ed