Need spec for indexable tool holder
#3
Hawkeye, I've posted my question on 6 forums and the only result Ive gotten was to look on the Sandvik site, which I already had done. Unless I am just not understanding what I see, I found nothing there but the description/spec of the insert.
If it was a holed insert,I would be o.k. but these are clamp type.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
Need spec for indexable tool holder - by chucketn - 05-25-2014, 09:33 AM
RE: Need spec for indexable tool holder - by chucketn - 05-25-2014, 10:30 AM
RE: Need spec for indexable tool holder - by EdK - 05-25-2014, 01:23 PM
RE: Need spec for indexable tool holder - by EdK - 05-25-2014, 04:52 PM



Users browsing this thread: 3 Guest(s)