Harrison L5 lathe rebuild

[Micktoon]

Hi All , I have got a bit more done to the lathe and am on the home stretch now. I have tested the motor , gearbox etc and al seems well so far, coolant pump all fitted apart from the pipes for the coolant and the wiring all finished now.

This is the rear of the lathe, with the coolant pump back in position and the wiring all tied up.





I mentioned I had got another neater RPM sensor and display, this is it here I got it from this Ebay seller from Hong Kong but quality item that arrived well packed in a couple of weeks and for £10 inc postage its got to be the answer to putting a RPM display on any machine really http://www.ebay.co.uk/itm/261307045946?_...EBIDX%3AIT . Here are a few photos of the one I have but not fitted to anything yet, the only other thing you need is a 12v DC supply and a bracket for the sensor. The actual display fits into a rectangle cut out in any panel or box and snaps into place.









BobKRV3000 kindly had the top of the crossslide ground for me ( cheers Bob ), it was rough and battered and the graduations were all but worn off anyway so I will just set it at 90 degrees and witness mark it then set it with potractor when needed. At least it looks smart now and I could not have read the graduations anyway before.



The chuck had already been overhauled ages ago so nice to just pick an item up , wipe it off and fit it , I think its the first thing I have done that too !



Change wheels looked tatty now so they got a go over and paint.



Tailstock had a few bits that needed fixing but all done and back together now, the morse taper inside the barrel is a bit rough but can be taken out to be done easy enough.



The saddle had new felt wipers fitted as well as a general good go over.




The apron was tested and the handwheel re drilled and tapped with larger thread on the wonky hole with the help of my mate Dave on his Emco FB2 mill ( cheers Dave ) My my mill is still sitting with the ram jammed in half way position so it can not be swiveled either way due to the wall at the moment ( the next job on the list )



The cabinet door has had a new Yale type lock fitted, I wondered what the hell the handle/catch looked like until I saw one for sale on Ebay and noticed the lock.





I am busy with the topslide now, it was rough around the edges so its been over to John Doubleboosts today to have the sides skimmed on his mill ( I am going to owe some favours out by the time this lathe is done ) But nice when people can help each other out with jobs, so thanks John. Once the topslide is on its just testing everything and setting everything up really and hopefully not finding any problems.

Cheers Mick.