05-10-2014, 05:47 PM
Looks good Ed. I'm really tempted to get one of those air/over jacks for my press, but I'm going to wait and see what you have to say about them after you've used yours for awhile.
One of the first things I did on my press was to tack weld a couple of large washers onto the ends of the table support bars. It keeps the bars from sliding all the way through. Once I had unknowingly bumped into one of them and pushed it through the frame, leaving the front channel sitting on about 1/8" of the support bar. Thankfully I caught it before getting too much pressure on the part I was pressing on.
![[Image: th_P4020165.jpg]](http://img.photobucket.com/albums/v82/Highpwr/Temp/th_P4020165.jpg)
One of the first things I did on my press was to tack weld a couple of large washers onto the ends of the table support bars. It keeps the bars from sliding all the way through. Once I had unknowingly bumped into one of them and pushed it through the frame, leaving the front channel sitting on about 1/8" of the support bar. Thankfully I caught it before getting too much pressure on the part I was pressing on.
![[Image: th_P4020165.jpg]](http://smg.photobucket.com/user/Highpwr/media/Temp/P4020165.jpg.html)
Willie