Shop Press

[EdK]

(05-04-2014, 11:09 AM)arvidj Wrote: I'm not sure if this is relevant but a level has never been withing 5 feet of my press. Never even thought about it. Usually I have some type of arbor plate on the "table" and they are far from level or machined or parallel in nature ... i.e. what ever I could find that looked to be strong enough.

I consider the press to be in the "brute force device" category and not a precision instrument.

I was afraid someone would interpret my use of the level as a level when I was only using it as a straight edge.

Thanks for the insight. I'm not going to fret about it then.

Ed