05-03-2014, 09:41 PM
Shawn, you're really hitting the ground running with your CNC. Lots of good stuff happening.
Seems to me I read something last year about milling plastics. I'm not positive, but I think they recommended lower RPM with fairly fast feed rates to keep the heat down. Might be worth experimenting with.
Seems to me I read something last year about milling plastics. I'm not positive, but I think they recommended lower RPM with fairly fast feed rates to keep the heat down. Might be worth experimenting with.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.