MetalworkingFun Forum › Machining › Projects v
Need a project

Thread Modes
Need a project
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#20
05-02-2014, 05:29 AM
Number 1 is a center drill. If it's a 60 degree center drill then it's typically used to drill the 60 degree tapered hole which allows you to turn parts between centers on your lathe using lathe centers.

Number 2 is an end mill used to mill stock.

Number 3 is 17428

Ed
Reply
Thanks given by:


Messages In This Thread
Need a project - by ironman - 04-29-2014, 03:09 PM
RE: Need a project - by DaveH - 04-29-2014, 04:13 PM
RE: Need a project - by DaveH - 04-29-2014, 04:21 PM
RE: Need a project - by DaveH - 04-29-2014, 04:30 PM
RE: Need a project - by doubleboost - 04-29-2014, 04:52 PM
RE: Need a project - by TomG - 04-29-2014, 05:13 PM
RE: Need a project - by DaveH - 04-29-2014, 05:38 PM
RE: Need a project - by TomG - 04-29-2014, 06:12 PM
RE: Need a project - by EdK - 04-30-2014, 05:09 AM
RE: Need a project - by Sunset Machine - 04-29-2014, 10:34 PM
RE: Need a project - by ironman - 04-30-2014, 12:12 AM
RE: Need a project - by ironman - 04-30-2014, 02:58 PM
RE: Need a project - by ironman - 04-30-2014, 03:02 PM
RE: Need a project - by DaveH - 05-01-2014, 08:26 AM
RE: Need a project - by DaveH - 05-01-2014, 08:30 AM
RE: Need a project - by ironman - 05-02-2014, 02:48 AM
RE: Need a project - by Mayhem - 05-01-2014, 08:07 PM
RE: Need a project - by ironman - 05-02-2014, 02:50 AM
RE: Need a project - by ironman - 05-02-2014, 02:54 AM
RE: Need a project - by EdK - 05-02-2014, 05:29 AM
RE: Need a project - by stevec - 05-02-2014, 05:57 AM
RE: Need a project - by Mayhem - 05-02-2014, 08:12 PM
RE: Need a project - by PixMan - 05-02-2014, 08:23 PM
RE: Need a project - by ironman - 05-03-2014, 02:10 AM
RE: Need a project - by ironman - 05-06-2014, 06:39 AM
RE: Need a project - by kenne - 06-12-2014, 09:55 PM
RE: Need a project - by ironman - 06-13-2014, 03:48 AM



Users browsing this thread: 2 Guest(s)