05-01-2014, 08:26 AM
Marius,
one pic at a time.
Pic 1, left hand side is a 'roughing end mill' on a Morse taper (3?) with a draw bar.
Right hand side is an 'end mill' on a Morse taper (3?) with a draw bar.
Pic 2, look end two 'slot mills' or some call 'center cutting end mills' used mainly for cutting slots.
Pic3, as Pic 2, look like 'slot mills'
The end mills are sometimes referred to as 2 flute, 3flute or 4flute and whether they are center cutting or not.
DaveH
one pic at a time.
Pic 1, left hand side is a 'roughing end mill' on a Morse taper (3?) with a draw bar.
Right hand side is an 'end mill' on a Morse taper (3?) with a draw bar.
Pic 2, look end two 'slot mills' or some call 'center cutting end mills' used mainly for cutting slots.
Pic3, as Pic 2, look like 'slot mills'
The end mills are sometimes referred to as 2 flute, 3flute or 4flute and whether they are center cutting or not.
DaveH