04-26-2014, 09:20 PM
I got a big tooling order in on Thursday. I love it when my ship ... ment comes in. This morning, I got some time to make a holder for the set of 5C collets. I had a chunk of 2 x 12, so I worked out a layout that would hold all 29 collets , plus a few spares. It really helps to mark out all of the sizes on the wood so that you can put them in order as you unpack them.
When I was almost done cleaning all of the collets, I found a duplicate. I had two 15/16" and no 15/32". Pretty easy to see how that could happen. The 5/16" is in the spin indexer because I already used it on a project.
When I was almost done cleaning all of the collets, I found a duplicate. I had two 15/16" and no 15/32". Pretty easy to see how that could happen. The 5/16" is in the spin indexer because I already used it on a project.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.