04-25-2014, 08:20 AM
Normally the designer/draughtsperson would talk to the machinist (if they have some sense they will) and between them they will sort out what is what. The machinist nearly always has more experience in making a part than the designer/draughtsperson so it best to work together.
However this is not always possible especially when it is not known where the parts will be made, so it is important to convey in the drawing what is required.
DaveH
However this is not always possible especially when it is not known where the parts will be made, so it is important to convey in the drawing what is required.
DaveH