04-24-2014, 07:33 AM
I'm going to replace the bearings and I've been advised to get double metal seals on the top bearing by a guy that I have been in contact with in QLD, who use to service these mills. I am going to ask him about the correct means of greasing the bottom bearings but I thought I'd ask you guys for your thoughts as well.
When I pulled the spindle, there was grease packed everywhere. I've included a section from the drawing of the head below as a reference. As these linear contact bearings don't have seals, I'm guessing the space between the two (the brown space) would be packed with grease, but what about the space above these (blue space) - should grease be packed in here as well?
When I pulled the spindle, there was grease packed everywhere. I've included a section from the drawing of the head below as a reference. As these linear contact bearings don't have seals, I'm guessing the space between the two (the brown space) would be packed with grease, but what about the space above these (blue space) - should grease be packed in here as well?
Hunting American dentists since 2015.