04-24-2014, 06:14 AM
I can't remember if you guys have discussed drilling the pin hole for the gear but, I'd recommend drilling it with the gear as a guide, about half way from each side.
Another thing I've wondered is, what about cutting the screw longer than needed and part it off so as to provide enough to make a "tap" to" finish size" the nut for a nice fit?
Another thing I've wondered is, what about cutting the screw longer than needed and part it off so as to provide enough to make a "tap" to" finish size" the nut for a nice fit?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.