Looks great Ed. I'd want a little more info on the fit of the feed gear to the screw. Is it a slip fit or RFT? (Really F'n Tight)
Can you measure the 12mm diameter with a really good micrometer that reads out in "tenths" or microns?
We need to design the nut, as I would make that FIRST (because it's tapped) and then make the screw fit into it snug.
Can you measure the 12mm diameter with a really good micrometer that reads out in "tenths" or microns?
We need to design the nut, as I would make that FIRST (because it's tapped) and then make the screw fit into it snug.