Fixing a Leaky RF-45 Mill Head - Grizzly G0519

[EdK]

(04-21-2014, 02:43 PM)henryarnold Wrote: Guys,

I can't believe it has been 2 years since I rebuilt my RF-45 mill head. My mill is still going strong. I have used it for many projects and recently the mill was moved to a new house without mishap. I'm still leak free.

My house move included a downsizing of tools. I had to sell the shop press I used for this rebuild. The good news is that I bought the shop press for $150 at HF and I sold it on Craig's List for $100. I don't think that is too bad of a deal.

Thanks for all the suggestions while I did the rebuild.

Best Regards,
Henry Arnold

Henry,

You must have done a lot better job than I did with mine because my mill still leaks after rebuilding it.

Ed

P.S. I hope you moved into a more fire resistant home.