MetalworkingFun Forum › Machinery › Milling Machines v
New To Me Milling Machine

Thread Modes
New To Me Milling Machine
the penguin Offline
Junior
****
Posts: 482
Threads: 89
Joined: Oct 2012
Location: camillus (syracuse), ny
The following 1 user Likes the penguin's post:
EdK (04-20-2014)
#15
04-20-2014, 07:18 PM
Yesterday, I worked on get the spindle perpendicular to the table.

Today, I cleaned up the table, pumped the oil ports full of way oil and adjusted all of the gibs. I'm very surprised, based on the units age, how tight and clean it actually is.
jack
Reply
Thanks given by:


Messages In This Thread
New To Me Milling Machine - by the penguin - 04-08-2014, 08:06 PM
RE: New To Me Milling Machine - by EdK - 04-09-2014, 05:21 AM
RE: New To Me Milling Machine - by stevec - 04-09-2014, 06:10 AM
RE: New To Me Milling Machine - by PixMan - 04-09-2014, 06:45 AM
RE: New To Me Milling Machine - by the penguin - 04-09-2014, 05:34 PM
RE: New To Me Milling Machine - by stevec - 04-10-2014, 05:44 AM
RE: New To Me Milling Machine - by Hawkeye - 04-10-2014, 08:45 PM
RE: New To Me Milling Machine - by stevec - 04-11-2014, 06:33 AM
RE: New To Me Milling Machine - by Hawkeye - 04-11-2014, 07:46 PM
RE: New To Me Milling Machine - by the penguin - 04-12-2014, 08:32 PM
RE: New To Me Milling Machine - by the penguin - 04-13-2014, 06:11 PM
RE: New To Me Milling Machine - by stevec - 04-13-2014, 06:56 PM
RE: New To Me Milling Machine - by the penguin - 04-19-2014, 10:21 AM
RE: New To Me Milling Machine - by Sunset Machine - 04-19-2014, 11:38 AM
RE: New To Me Milling Machine - by the penguin - 04-20-2014, 07:18 PM



Users browsing this thread: 1 Guest(s)