04-18-2014, 10:44 PM
I learned a lot about this tool this morning. The Yuasa manual gave me a few hints, but leaves out a lot of detail. No cams on this one, but there should be two large buttons to help register the starting position. I'll work out the dimensions and make those soon.
I did replace the locking bolt that shows on the side of the body in the top photo. The aluminum knob works very well and is a lot closer to the original one.
I did replace the locking bolt that shows on the side of the body in the top photo. The aluminum knob works very well and is a lot closer to the original one.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.