04-18-2014, 04:20 PM
Ed,
One other thing that is important. Your large dameter length of 3.250 is fairly critical once you mount the adpater to your lead screw because it sets the mesh of the pinon gear to the ring gear. To a point you can move the ring gear out using the supplied shims but it should be close. I had to remove my adpater and take just a small amount off the face of the large diameter to move the ring gear in just a bit. I ended up only needing a small amount of shim.
Henry
One other thing that is important. Your large dameter length of 3.250 is fairly critical once you mount the adpater to your lead screw because it sets the mesh of the pinon gear to the ring gear. To a point you can move the ring gear out using the supplied shims but it should be close. I had to remove my adpater and take just a small amount off the face of the large diameter to move the ring gear in just a bit. I ended up only needing a small amount of shim.
Henry
henryarnold, proud to be a member of MetalworkingFun Forum since Apr 2012.