04-18-2014, 03:52 PM
(This post was last modified: 04-18-2014, 04:12 PM by henryarnold.)
Ed,
I did the same adapter for my mill. I turned and threaded the outside diameters and then used a boring bar to do a very close tolerance inside bore. I also added two set screws to the shaft and slot for the gear.
[attachment=8157]
I did the same adapter for my mill. I turned and threaded the outside diameters and then used a boring bar to do a very close tolerance inside bore. I also added two set screws to the shaft and slot for the gear.
[attachment=8157]
henryarnold, proud to be a member of MetalworkingFun Forum since Apr 2012.