MetalworkingFun Forum › Machining › General Metalworking Discussion v
[HELP] Concentric Turning To A Bore

Thread Modes
Help Concentric Turning To A Bore
EdK Offline
Whipping Boy
*******
Posts: 8,860
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
#10
04-17-2014, 11:59 AM
(04-16-2014, 07:23 PM)f350ca Wrote: ...
Or drill and ream then turn a shaft to fit the reamed hole and use it as an arbour to do the rest of the machining.

This was my thought also.

Ed
Reply
Thanks given by:


Messages In This Thread
Concentric Turning To A Bore - by EdK - 04-16-2014, 05:42 PM
RE: Concentric Turning To A Bore - by Mayhem - 04-16-2014, 06:58 PM
RE: Concentric Turning To A Bore - by f350ca - 04-16-2014, 07:23 PM
RE: Concentric Turning To A Bore - by EdK - 04-17-2014, 11:59 AM
RE: Concentric Turning To A Bore - by DaveH - 04-16-2014, 08:11 PM
RE: Concentric Turning To A Bore - by PixMan - 04-16-2014, 09:40 PM
RE: Concentric Turning To A Bore - by TomG - 04-16-2014, 10:12 PM
RE: Concentric Turning To A Bore - by EdK - 04-17-2014, 12:05 PM
RE: Concentric Turning To A Bore - by PixMan - 04-17-2014, 06:12 AM
RE: Concentric Turning To A Bore - by TomG - 04-17-2014, 06:37 AM
RE: Concentric Turning To A Bore - by EdK - 04-17-2014, 12:15 PM
RE: Concentric Turning To A Bore - by EdK - 04-17-2014, 12:18 PM
RE: Concentric Turning To A Bore - by TomG - 04-17-2014, 12:57 PM
RE: Concentric Turning To A Bore - by henryarnold - 04-18-2014, 03:52 PM
RE: Concentric Turning To A Bore - by EdK - 04-18-2014, 03:55 PM
RE: Concentric Turning To A Bore - by henryarnold - 04-18-2014, 04:10 PM
RE: Concentric Turning To A Bore - by henryarnold - 04-18-2014, 04:20 PM
RE: Concentric Turning To A Bore - by EdK - 04-18-2014, 04:26 PM



Users browsing this thread: 5 Guest(s)