04-16-2014, 03:16 PM
Well Lads the first chips are flying,
As I do not have a reliable mill vice I used my dividing head to provide a vertical plane and 3-2-1- blocks to keep things square.
The first job was to shape up the material for the cyl head.
After getting it square I reduced the area underneath so the real work could be done at a later date.
The next job will be to rough out the piston and liner blanks.
Dirty stuff this iron, Chips fly everywhere.
Brian
As I do not have a reliable mill vice I used my dividing head to provide a vertical plane and 3-2-1- blocks to keep things square.
The first job was to shape up the material for the cyl head.
After getting it square I reduced the area underneath so the real work could be done at a later date.
The next job will be to rough out the piston and liner blanks.
Dirty stuff this iron, Chips fly everywhere.
Brian
