04-12-2014, 03:18 PM
(This post was last modified: 04-12-2014, 03:19 PM by roundrocktom.)
Side note, used a new rotor for a '93 Honda Accord sitting on the shop shelf. 0.000 5" indicator. both sides are parallel within 0.000 1". Not an issue for dialing in the head alignment.
Oddest part... I was getting 0.002" error tramming the head. I hadn't snugged the collet tight enough. Once snugged up, well within 0.000 5 (fine for me). Pulling my full body weight on the head gives 0.000 5" error.
Oddest part... I was getting 0.002" error tramming the head. I hadn't snugged the collet tight enough. Once snugged up, well within 0.000 5 (fine for me). Pulling my full body weight on the head gives 0.000 5" error.
roundrocktom, proud to be a member of MetalworkingFun Forum since Mar 2014.