here's a shot of the start of the scratch pass to thread the Z Axis screw, this screw was to short for me to have the nut on the outboard end of the spindle so I had a lot more sticking out of the chuck then I wanted. It turned ok, just that I would of been a lot happier with the setup if I had of only had like 4 inches sticking out. Was going to put the nut inside the chuck behind the jaws but there wasn't enough room to set it up that way
DA
came home from hardware store to find this sitting at my back door begging for chips and some paint
DA
came home from hardware store to find this sitting at my back door begging for chips and some paint
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!