04-10-2014, 08:07 AM
finally got the part shown in the last video on the shaper it still needs a couple finishing touches.
and the handle that a friend in Tulsa cut the pattern for with his CNC Router
I've made and adjustment to the pattern by removing the rounded part because of the length of the stud that is in the shaper (original part), I plan on scaling the pattern up a little its on the small side for getting a good grip on. But it looks a heck of a lot better then the other one that I cut the pattern for with a pocket knife.
DA
and the handle that a friend in Tulsa cut the pattern for with his CNC Router
I've made and adjustment to the pattern by removing the rounded part because of the length of the stud that is in the shaper (original part), I plan on scaling the pattern up a little its on the small side for getting a good grip on. But it looks a heck of a lot better then the other one that I cut the pattern for with a pocket knife.
DA
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!