Some long cuts in plate
#15
(04-03-2014, 08:28 PM)arvidj Wrote: I've gotten stuff from here because its withing driving distance of my house.

http://www.discountsteel.com/items/1018_...nts=&qty=1

Not necessarily applicable for Ben but it does give you an idea of what stuff costs in other areas. I also like it because it gives me the weight and if I happen to be able to find what I am looking for in their "drops" area ... very well organized and indoors ... I have a clue what it will cost me as drops are by weight.

Arvid

That's where I used to buy all of my steel from when I still lived in Minneapolis. Since I've moved about 50 miles or so west of there I started getting my steel from Midwest Iron in St. Cloud. I was paying about half compared to Discount Steel. Now the margin has narrowed a bit but it's still substantially less. It's a family owned business that's been around for a long time and I assume the overhead is much lower than Discount Steel's. But, it would be quite a drive for you Arvid.

Ed
Reply
Thanks given by:


Messages In This Thread
Some long cuts in plate - by hswaters - 03-21-2014, 11:49 PM
RE: Some long cuts in plate - by awemawson - 03-22-2014, 02:57 AM
RE: Some long cuts in plate - by stevec - 03-22-2014, 06:05 AM
RE: Some long cuts in plate - by DaveH - 03-22-2014, 08:34 AM
RE: Some long cuts in plate - by Sunset Machine - 03-22-2014, 09:21 AM
RE: Some long cuts in plate - by hswaters - 03-22-2014, 10:15 AM
RE: Some long cuts in plate - by roundrocktom - 03-22-2014, 10:53 AM
RE: Some long cuts in plate - by hswaters - 03-22-2014, 12:24 PM
RE: Some long cuts in plate - by hswaters - 04-03-2014, 10:16 AM
RE: Some long cuts in plate - by stevec - 04-03-2014, 12:22 PM
RE: Some long cuts in plate - by hswaters - 04-03-2014, 05:08 PM
RE: Some long cuts in plate - by stevec - 04-03-2014, 05:54 PM
RE: Some long cuts in plate - by arvidj - 04-03-2014, 08:28 PM
RE: Some long cuts in plate - by hswaters - 04-03-2014, 08:44 PM
RE: Some long cuts in plate - by EdK - 04-03-2014, 08:48 PM



Users browsing this thread: 2 Guest(s)