|
Spring steel sheet.
|
Okay! stupid answers are my speciality! Could you draw the material over a sharp (+/-) 90° angle sorta like we do with a new sheet of sandpaper/emery cloth?
 As a matter of curiosity what would the intended end use be?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Spring steel sheet. - by Highpower - 03-19-2014, 10:13 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 01:49 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 04:31 PM
RE: Spring steel sheet. - by f350ca - 03-21-2014, 04:43 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 09:22 PM
RE: Spring steel sheet. - by TomG - 03-21-2014, 06:04 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 07:02 PM
RE: Spring steel sheet. - by wrustle - 03-25-2014, 05:38 PM
RE: Spring steel sheet. - by Highpower - 03-26-2014, 10:33 AM
RE: Spring steel sheet. - by f350ca - 03-26-2014, 06:31 PM
RE: Spring steel sheet. - by stevec - 03-27-2014, 06:34 AM
RE: Spring steel sheet. - by Highpower - 04-09-2014, 09:58 PM
|
