MetalworkingFun Forum › Machining › General Metalworking Discussion v
Spring steel sheet.

Thread Modes
Spring steel sheet.
wrustle Offline
Junior
****
Posts: 438
Threads: 67
Joined: Sep 2012
Location: Central Mass.
#8
03-25-2014, 05:38 PM
(03-19-2014, 10:13 PM)Highpower Wrote: Any suggestions on how to straighten out a roll of blue spring steel sheet and get it flat again - without a set of sheet metal rollers to work with?

[Image: 0005302-11.jpg]


How about buying a "flat" of blue spring steel instead? Rotfl
Reply
Thanks given by:


Messages In This Thread
Spring steel sheet. - by Highpower - 03-19-2014, 10:13 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 01:49 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 04:31 PM
RE: Spring steel sheet. - by f350ca - 03-21-2014, 04:43 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 09:22 PM
RE: Spring steel sheet. - by TomG - 03-21-2014, 06:04 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 07:02 PM
RE: Spring steel sheet. - by wrustle - 03-25-2014, 05:38 PM
RE: Spring steel sheet. - by Highpower - 03-26-2014, 10:33 AM
RE: Spring steel sheet. - by f350ca - 03-26-2014, 06:31 PM
RE: Spring steel sheet. - by stevec - 03-27-2014, 06:34 AM
RE: Spring steel sheet. - by Highpower - 04-09-2014, 09:58 PM



Users browsing this thread: 2 Guest(s)