03-22-2014, 10:31 AM
Two More. Sorry about shawdows, I'm let the camera strap block the flash!
Mitutoyo Bore Gage... checking for taper during engine rebuilds!
Camera strap appeared!
Balls -- you don't see these much any more, but full set of std, +0.001 +.002 and +0.003. Handy if a hole is spec'd at -0 +2 thousands. Note inside lid, bought from S&R on March 1995. Doesn't seem that long ago. Tip, Machinery hand book is your friend when using these to determine intermediate bore size
VCI - Volatile Corrosion Inhibitor. McMaster Carr item. Pricey, but cheap insurance.
Mitutoyo Bore Gage... checking for taper during engine rebuilds!
Camera strap appeared!
Balls -- you don't see these much any more, but full set of std, +0.001 +.002 and +0.003. Handy if a hole is spec'd at -0 +2 thousands. Note inside lid, bought from S&R on March 1995. Doesn't seem that long ago. Tip, Machinery hand book is your friend when using these to determine intermediate bore size
VCI - Volatile Corrosion Inhibitor. McMaster Carr item. Pricey, but cheap insurance.
roundrocktom, proud to be a member of MetalworkingFun Forum since Mar 2014.