MetalworkingFun Forum › Machining › General Metalworking Discussion v
Spring steel sheet.

Thread Modes
Spring steel sheet.
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
The following 1 user Likes TomG's post:
DaveH (03-21-2014)
#5
03-21-2014, 06:04 PM
Dave has a set of rollers, send it to him. :)

Try dragging it across the corner of a 2x4 with as much pressure as you can muster. How thick is the stuff?

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: Highpower


Messages In This Thread
Spring steel sheet. - by Highpower - 03-19-2014, 10:13 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 01:49 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 04:31 PM
RE: Spring steel sheet. - by f350ca - 03-21-2014, 04:43 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 09:22 PM
RE: Spring steel sheet. - by TomG - 03-21-2014, 06:04 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 07:02 PM
RE: Spring steel sheet. - by wrustle - 03-25-2014, 05:38 PM
RE: Spring steel sheet. - by Highpower - 03-26-2014, 10:33 AM
RE: Spring steel sheet. - by f350ca - 03-26-2014, 06:31 PM
RE: Spring steel sheet. - by stevec - 03-27-2014, 06:34 AM
RE: Spring steel sheet. - by Highpower - 04-09-2014, 09:58 PM



Users browsing this thread: 6 Guest(s)