Spring steel sheet.
#3
Willie,
Rotfl
Without a set of rollers - really difficult.
I know it can be straightened by heating and hammering it flat, but takes a lot of practice and skill. Not sure what to do if it ends up full of hammer marks Big Grin
Smiley-eatdrink004
DaveH
Reply
Thanks given by: Highpower


Messages In This Thread
Spring steel sheet. - by Highpower - 03-19-2014, 10:13 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 01:49 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 04:31 PM
RE: Spring steel sheet. - by f350ca - 03-21-2014, 04:43 PM
RE: Spring steel sheet. - by Highpower - 03-21-2014, 09:22 PM
RE: Spring steel sheet. - by TomG - 03-21-2014, 06:04 PM
RE: Spring steel sheet. - by DaveH - 03-21-2014, 07:02 PM
RE: Spring steel sheet. - by wrustle - 03-25-2014, 05:38 PM
RE: Spring steel sheet. - by Highpower - 03-26-2014, 10:33 AM
RE: Spring steel sheet. - by f350ca - 03-26-2014, 06:31 PM
RE: Spring steel sheet. - by stevec - 03-27-2014, 06:34 AM
RE: Spring steel sheet. - by Highpower - 04-09-2014, 09:58 PM



Users browsing this thread: 1 Guest(s)