03-16-2014, 07:48 AM
(This post was last modified: 03-16-2014, 07:51 AM by Sunset Machine.)
I needed to pull the 6x12 magnetic chuck off for cleaning and the manual says to regrind it with a 60H wheel and coolant, .050" stepover, .0003" downfeed.
It burnt badly (dark streaks) so I tried a 60K with a noticeable improvement, but still leaving streaks. I tried .0001" at a .025 stepover, same results. Last night, a 46K. Still streaking.
Any words of wisdom would sure be appreciated.
It burnt badly (dark streaks) so I tried a 60K with a noticeable improvement, but still leaving streaks. I tried .0001" at a .025 stepover, same results. Last night, a 46K. Still streaking.
Any words of wisdom would sure be appreciated.