MetalworkingFun Forum › Machining › Welding & Casting v
How it used to be done

Thread Modes
How it used to be done
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
#3
04-26-2012, 04:39 PM
I wanna be the guy in the bowler hatBig GrinBig GrinBig Grin

Look at the early part of the video, when one guy is standing on the ring, see where his hammer will go if he missed. SlapheadSlapheadSlaphead

They certainly can swing them hammers SmileSmileSmile
Smiley-eatdrink004
DaveH
Reply
Thanks given by:


Messages In This Thread
How it used to be done - by doubleboost - 04-26-2012, 04:26 PM
RE: How it used to be done - by krv3000 - 04-26-2012, 04:35 PM
RE: How it used to be done - by DaveH - 04-26-2012, 04:39 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 09:42 AM
RE: How it used to be done - by DaveH - 04-27-2012, 09:55 AM
RE: How it used to be done - by RobWilson - 04-27-2012, 12:03 PM
RE: How it used to be done - by EdK - 04-27-2012, 12:09 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 12:17 PM
RE: How it used to be done - by stevec - 04-27-2012, 02:56 PM
RE: How it used to be done - by DaveH - 04-27-2012, 03:07 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 03:37 PM
RE: How it used to be done - by DaveH - 04-27-2012, 03:42 PM
RE: How it used to be done - by EdK - 04-27-2012, 04:00 PM
RE: How it used to be done - by RobWilson - 04-27-2012, 04:11 PM
RE: How it used to be done - by Rickabilly - 06-13-2012, 03:47 PM
RE: How it used to be done - by RobWilson - 06-13-2012, 04:01 PM
RE: How it used to be done - by Rickabilly - 06-14-2012, 05:03 AM



Users browsing this thread: 5 Guest(s)