MetalworkingFun Forum › Machining › Gunsmithing v
Cast And Plate

Thread Modes
Cast And Plate
Highpower Offline
JAFO
******
Posts: 4,460
Threads: 184
Joined: Feb 2012
Location: Missouri, USA
#21
03-06-2014, 11:32 PM
(03-06-2014, 10:48 PM)Old Iron` Wrote: Then I need to finish the SKS I was working on a few months ago. Had to lay off it till the wife forgot Abbot me blowing the side of 2 stock off with it.

OUCH! What went wrong?
Willie
Reply
Thanks given by:


Messages In This Thread
Cast And Plate - by Old Iron - 02-18-2014, 10:55 PM
RE: Cast And Plate - by Highpower - 02-19-2014, 07:29 AM
RE: Cast And Plate - by aametalmaster - 02-19-2014, 08:47 PM
RE: Cast And Plate - by Mayhem - 02-20-2014, 08:21 AM
RE: Cast And Plate - by Welrod - 02-20-2014, 09:18 AM
RE: Cast And Plate - by Old Iron - 03-02-2014, 08:59 AM
RE: Cast And Plate - by Highpower - 03-02-2014, 04:25 PM
RE: Cast And Plate - by Welrod - 03-02-2014, 12:16 PM
RE: Cast And Plate - by Old Iron - 03-03-2014, 07:22 AM
RE: Cast And Plate - by Old Iron - 03-03-2014, 08:44 PM
RE: Cast And Plate - by Highpower - 03-03-2014, 10:24 PM
RE: Cast And Plate - by Old Iron - 03-04-2014, 06:01 AM
RE: Cast And Plate - by Mayhem - 03-04-2014, 07:24 AM
RE: Cast And Plate - by Highpower - 03-04-2014, 02:16 PM
RE: Cast And Plate - by Welrod - 03-04-2014, 02:09 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 07:35 AM
RE: Cast And Plate - by Highpower - 03-05-2014, 12:22 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 11:44 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:19 AM
RE: Cast And Plate - by Old Iron - 03-06-2014, 10:48 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:32 PM
RE: Cast And Plate - by Old Iron - 03-07-2014, 01:12 PM
RE: Cast And Plate - by Highpower - 03-07-2014, 02:36 PM



Users browsing this thread: 1 Guest(s)