How to Make Custom Length Bandsaw Blades Without Welding
#39
Eurika! Flux from MSC did the job. 2 tries with first blade, 1 try with second! I tested the joint on the first one by flexing in my hands and then sucessfully coiling the blade!
Thanks Tom for the jig, and thanks to all that perservered through my learning! What makes it special is I used solder I found in my Dad's torch kit!

Chuck


Attached Files Thumbnail(s)
   
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:


Messages In This Thread
RE: How to Make Custom Length Bandsaw Blades Without Welding - by chucketn - 03-05-2014, 01:42 PM



Users browsing this thread: 6 Guest(s)