MetalworkingFun Forum › Machining › How-To's v
Screw Cutting on a Lathe

Thread Modes
Screw Cutting on a Lathe
dallen Offline
Senior
*****
Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma
#5
04-26-2012, 07:36 AM
(04-17-2012, 05:56 PM)krv3000 Wrote: hi all i have a vid of cuting threds its a proper one

if possible I would like to watch that videoBig Grin
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
Screw Cutting on a Lathe - by DaveH - 04-17-2012, 04:51 PM
RE: Screw Cutting on a Lathe - by doubleboost - 04-17-2012, 05:02 PM
RE: Screw Cutting on a Lathe - by krv3000 - 04-17-2012, 05:56 PM
RE: Screw Cutting on a Lathe - by dallen - 04-26-2012, 07:36 AM
RE: Screw Cutting on a Lathe - by EdK - 04-17-2012, 06:06 PM
RE: Screw Cutting on a Lathe - by DaveH - 04-26-2012, 08:44 AM
RE: Screw Cutting on a Lathe - by doubleboost - 04-26-2012, 08:56 AM
RE: Screw Cutting on a Lathe - by DaveH - 04-26-2012, 09:14 AM
RE: Screw Cutting on a Lathe - by krv3000 - 04-26-2012, 04:23 PM
RE: Screw Cutting on a Lathe - by krv3000 - 04-26-2012, 04:33 PM



Users browsing this thread: 2 Guest(s)