02-26-2014, 02:32 PM
Well, I got out the digital camera and headed to the shop to take pictures of the jig and the flux I was using. Typical, the camera lit up and when I took the picture, it went black... Batteries died! So, batteries charging, pics tomorrow.
Meanwhile, the past flux I was using is Radnor Stay-Clean. Says on the bottle it contains Zinc Cloride, and not recommended for Aluminum or electronics soldering. Is this the right stuff?
I taught High Reliability Soldering for electronics in the USAF for 10 years, so I have some knowledge of soldering, just not much on silver soldering. I remember my Dad soldering with an Accetylene/Air Torch, which I now have, but that was 40-50 years ago.
Chuck
Meanwhile, the past flux I was using is Radnor Stay-Clean. Says on the bottle it contains Zinc Cloride, and not recommended for Aluminum or electronics soldering. Is this the right stuff?
I taught High Reliability Soldering for electronics in the USAF for 10 years, so I have some knowledge of soldering, just not much on silver soldering. I remember my Dad soldering with an Accetylene/Air Torch, which I now have, but that was 40-50 years ago.
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
The difficult takes me a while, the impossible takes a little longer.