First real project on the mill

Thread Modes

First real project on the mill

EdK

Whipping Boy

Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota

04-25-2012, 03:43 PM

Dan,

Fantastic job on the install. I also have an Enco RF-45 clone mill, an older one than yours, and tried mounting a 'Z' DRO to it but ended up having to take it off because it was binding. The quill has some slop in it so it can twist when lowered. I'm not sure how to deal with that problem yet.

Ed

Like Post

« Next Oldest | Next Newest »

Messages In This Thread

First real project on the mill - by DanH - 04-25-2012, 02:22 PM

RE: First real project on the mill - by EdK - 04-25-2012, 03:43 PM

RE: First real project on the mill - by doubleboost - 04-25-2012, 03:55 PM

RE: First real project on the mill - by krv3000 - 04-25-2012, 05:13 PM

RE: First real project on the mill - by DanH - 04-25-2012, 05:21 PM

RE: First real project on the mill - by EdK - 04-25-2012, 06:39 PM

RE: First real project on the mill - by DaveH - 04-25-2012, 08:49 PM

RE: First real project on the mill - by DanH - 04-27-2012, 12:43 PM

RE: First real project on the mill - by RobWilson - 04-26-2012, 12:29 PM