The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 864 - File: showthread.php PHP 7.4.33 (FreeBSD)
File Line Function
/showthread.php 864 errorHandler->error



MetalworkingFun Forum › Machining › Gunsmithing v
Cast And Plate

Thread Modes
Cast And Plate
Old Iron Offline
Freshman
**
Posts: 29
Threads: 4
Joined: Feb 2014
Location: Alabama
The following 2 users Like Old Iron's post:
Highpower (02-19-2014), aametalmaster (02-19-2014)
#1
02-18-2014, 10:55 PM
I cast most of my own bullets and then copper plate them. It is time consuming but I find it fun.

Picture is some 308 150gr flat nose I just finished. I'm going to cast some 380 apc in the morning.

Paul


Attached Files Thumbnail(s)
   
Old Iron`, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:


Messages In This Thread
Cast And Plate - by Old Iron - 02-18-2014, 10:55 PM
RE: Cast And Plate - by Highpower - 02-19-2014, 07:29 AM
RE: Cast And Plate - by aametalmaster - 02-19-2014, 08:47 PM
RE: Cast And Plate - by Mayhem - 02-20-2014, 08:21 AM
RE: Cast And Plate - by Welrod - 02-20-2014, 09:18 AM
RE: Cast And Plate - by Old Iron - 03-02-2014, 08:59 AM
RE: Cast And Plate - by Highpower - 03-02-2014, 04:25 PM
RE: Cast And Plate - by Welrod - 03-02-2014, 12:16 PM
RE: Cast And Plate - by Old Iron - 03-03-2014, 07:22 AM
RE: Cast And Plate - by Old Iron - 03-03-2014, 08:44 PM
RE: Cast And Plate - by Highpower - 03-03-2014, 10:24 PM
RE: Cast And Plate - by Old Iron - 03-04-2014, 06:01 AM
RE: Cast And Plate - by Mayhem - 03-04-2014, 07:24 AM
RE: Cast And Plate - by Highpower - 03-04-2014, 02:16 PM
RE: Cast And Plate - by Welrod - 03-04-2014, 02:09 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 07:35 AM
RE: Cast And Plate - by Highpower - 03-05-2014, 12:22 PM
RE: Cast And Plate - by Old Iron - 03-05-2014, 11:44 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:19 AM
RE: Cast And Plate - by Old Iron - 03-06-2014, 10:48 PM
RE: Cast And Plate - by Highpower - 03-06-2014, 11:32 PM
RE: Cast And Plate - by Old Iron - 03-07-2014, 01:12 PM
RE: Cast And Plate - by Highpower - 03-07-2014, 02:36 PM



Users browsing this thread: 2 Guest(s)