MetalworkingFun Forum › Machining › General Metalworking Discussion v
VFDs

Thread Modes
VFDs
stevec Offline
69 yr. old senior
*****
Posts: 2,685
Threads: 29
Joined: Feb 2012
Location: Nova Scotia, Canada
#22
02-15-2014, 06:45 PM
Thanks Ed, take your time, I'm in no rush. Shop time is very limited here due to the temperatures. Eventually I'll make sure my round column mill drill can fill the gap while I redo the "drive" of my Tree mill and install the vfd .
More #@%? snow on the way tomorrow, I'll be busy getting my share of fresh air.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
VFDs - by stevec - 02-10-2014, 02:59 PM
RE: VFDs - by dallen - 02-10-2014, 03:01 PM
RE: VFDs - by Hawkeye - 02-10-2014, 05:53 PM
RE: VFDs - by stevec - 02-10-2014, 06:52 PM
RE: VFDs - by dallen - 02-10-2014, 07:10 PM
RE: VFDs - by stevec - 02-11-2014, 08:59 AM
RE: VFDs - by f350ca - 02-10-2014, 07:55 PM
RE: VFDs - by dallen - 02-11-2014, 09:45 AM
RE: VFDs - by stevec - 02-11-2014, 01:13 PM
RE: VFDs - by EdK - 02-11-2014, 01:19 PM
RE: VFDs - by stevec - 02-11-2014, 08:09 PM
RE: VFDs - by stevec - 02-12-2014, 08:46 AM
RE: VFDs - by Highpower - 02-12-2014, 10:36 AM
RE: VFDs - by Mayhem - 02-11-2014, 05:43 PM
RE: VFDs - by stevec - 02-11-2014, 08:12 PM
RE: VFDs - by doubleboost - 02-11-2014, 05:59 PM
RE: VFDs - by stevec - 02-11-2014, 08:14 PM
RE: VFDs - by f350ca - 02-11-2014, 09:31 PM
RE: VFDs - by stevec - 02-12-2014, 12:24 PM
RE: VFDs - by Highpower - 02-12-2014, 02:53 PM
RE: VFDs - by EdK - 02-15-2014, 12:09 PM
RE: VFDs - by stevec - 02-15-2014, 06:45 PM
RE: VFDs - by EdK - 02-15-2014, 07:03 PM
RE: VFDs - by Hopefuldave - 02-18-2014, 07:16 AM
RE: VFDs - by stevec - 02-18-2014, 08:34 AM
RE: VFDs - by EdK - 02-18-2014, 12:42 PM
RE: VFDs - by stevec - 02-18-2014, 07:06 PM
RE: VFDs - by stevec - 02-18-2014, 07:27 PM



Users browsing this thread: 5 Guest(s)