(02-11-2014, 01:19 PM)EdK Wrote: Steve,Ed what I would like to do is set the parameters for maximum output frequency at around 90 Hz.
What are some of the specific instructions you're looking for?
Ed
I also wonder if that would make full sweep of the pot on the face of my VFD, it presently reaches 90 Hz. with about only 1/4 of it's rotation.
Here are some relative (?) pages of my manual.
![Bitmap Image .bmp](http://www.metalworkingfun.com/images/attachtypes/image.gif)
![Bitmap Image .bmp](http://www.metalworkingfun.com/images/attachtypes/image.gif)
![Bitmap Image .bmp](http://www.metalworkingfun.com/images/attachtypes/image.gif)
![Bitmap Image .bmp](http://www.metalworkingfun.com/images/attachtypes/image.gif)
I don't know if you can enlarge and read those, when I scanned them and printed them they came out clear and full page.
If I haven't scared you off by now and you think we should communicate privately let me know.
Steve
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.