02-10-2014, 02:59 PM
I today wired my Huanyang VFD to my 3hp 3 phase motor that was originally on my Tree mill. The bare basic wiring instructions worked and I'm pleased to say the motor turns, reverses and speeds up or down with the pot on the panel of the HY04D023B.
However, scary sounds and vibes start when I go beyond 120 or so HZ.- at only about half the turn of the pot.
Other of the many features purportedly capable of the VFD are vaguely documented by the poorly translated manual so I was just hoping that some of my homebuddys here might have or know of some English instructions or experience.
However, scary sounds and vibes start when I go beyond 120 or so HZ.- at only about half the turn of the pot.
Other of the many features purportedly capable of the VFD are vaguely documented by the poorly translated manual so I was just hoping that some of my homebuddys here might have or know of some English instructions or experience.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.