04-23-2012, 10:13 AM
Dave,
Hope my post didn't come across as questioning your work. I was asking a question. (sometimes the problem with typing on boards, the mystified look on my face should have cleared it up).
I don't cut enough tapers.
Did something similar to what your doing, had to clean up the abused internal tapers on my 3 jaw and collet chuck for the Colchester.
Still haven't mastered measuring the dia, when making taperlock hubs I have to put them in the bore to be sure I got the dia right and have enough room to the shoulder to get them to tighten.
Greg
Hope my post didn't come across as questioning your work. I was asking a question. (sometimes the problem with typing on boards, the mystified look on my face should have cleared it up).
I don't cut enough tapers.
Did something similar to what your doing, had to clean up the abused internal tapers on my 3 jaw and collet chuck for the Colchester.
Still haven't mastered measuring the dia, when making taperlock hubs I have to put them in the bore to be sure I got the dia right and have enough room to the shoulder to get them to tighten.
Greg
Free advice is worth exactly what you payed for it.
Greg
Greg