02-08-2014, 04:16 PM
The Nicole set Ed linked to is very good. We use them all the time in our Cnc Okuma lathe.
The initial cost may be a bit hard to accept, but once it is set up in a tool holder and left there, any time you need you a groove, screw in an insert and cut the groove......you will be loving how cheap the initial cost really turns out to be!
The initial cost may be a bit hard to accept, but once it is set up in a tool holder and left there, any time you need you a groove, screw in an insert and cut the groove......you will be loving how cheap the initial cost really turns out to be!