MetalworkingFun Forum › Machining › Projects v
ER Collet Chuck Pt. 3

Thread Modes
ER Collet Chuck Pt. 3
Wongster Offline
Junior
****
Posts: 301
Threads: 30
Joined: Mar 2012
Location: Singapore
#11
04-23-2012, 09:10 AM
Seriously Dave, how do you make it so shiny and nice?

Also, do you have a few pics showing the recessing being cut? keen to know the tool position relative to the face of the work piece.

Regards,
Wong
Wongster
http://www.wongstersproduction.com

Proud to be a member of MetalworkingFun Forum since Mar 2012.
Reply
Thanks given by:


Messages In This Thread
ER Collet Chuck Pt. 3 - by DaveH - 04-22-2012, 11:47 AM
RE: ER Collet Chuck Pt 3 - by DaveH - 04-22-2012, 12:23 PM
RE: ER Collet Chuck Pt 3 - by DaveH - 04-22-2012, 12:26 PM
RE: ER Collet Chuck Pt. 3 - by doubleboost - 04-22-2012, 03:24 PM
RE: ER Collet Chuck Pt. 3 - by EdK - 04-22-2012, 03:49 PM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 03:19 AM
RE: ER Collet Chuck Pt. 3 - by aametalmaster - 04-22-2012, 07:18 PM
RE: ER Collet Chuck Pt. 3 - by krv3000 - 04-23-2012, 02:09 AM
RE: ER Collet Chuck Pt. 3 - by Mayhem - 04-23-2012, 05:51 AM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 09:04 AM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-23-2012, 09:10 AM
RE: ER Collet Chuck Pt. 3 - by DaveH - 04-25-2012, 10:47 PM
RE: ER Collet Chuck Pt. 3 - by Wongster - 04-25-2012, 11:26 PM
RE: ER Collet Chuck Pt. 3 - by dallen - 04-26-2012, 07:40 AM
RE: ER Collet Chuck Pt. 3 - by DaveH - 04-26-2012, 08:41 AM



Users browsing this thread: 1 Guest(s)