Source for metric set screws?

Hello There, Guest! Register

Thread Modes

Source for metric set screws?

PixMan Offline

Offline

Resident Pariah

Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA

#5

02-03-2014, 11:18 AM

Funny that when I looked at the available metric thread pitches on my lathe I found that I can single point a 0.75 thread but no setting for 0.70mm

Reply

« Next Oldest | Next Newest »

Messages In This Thread

Source for metric set screws? - by Highpower - 02-02-2014, 04:48 PM

RE: Source for metric set screws? - by TomG - 02-03-2014, 12:27 AM

RE: Source for metric set screws? - by Highpower - 02-03-2014, 01:38 AM

RE: Source for metric set screws? - by Mayhem - 02-03-2014, 06:19 AM

RE: Source for metric set screws? - by Highpower - 02-03-2014, 05:04 PM

RE: Source for metric set screws? - by PixMan - 02-03-2014, 11:18 AM

RE: Source for metric set screws? - by unioncreek - 02-03-2014, 04:19 PM

RE: Source for metric set screws? - by EdK - 02-03-2014, 05:07 PM

RE: Source for metric set screws? - by Highpower - 02-03-2014, 05:46 PM

RE: Source for metric set screws? - by Arbalest - 02-03-2014, 05:44 PM

RE: Source for metric set screws? - by PixMan - 02-05-2014, 07:14 AM

RE: Source for metric set screws? - by awemawson - 02-05-2014, 07:56 AM

RE: Source for metric set screws? - by Mayhem - 02-05-2014, 08:01 AM

RE: Source for metric set screws? - by Highpower - 02-05-2014, 02:11 PM

RE: Source for metric set screws? - by stevec - 02-06-2014, 06:53 AM

Users browsing this thread: 3 Guest(s)