MetalworkingFun Forum › Machining › General Metalworking Discussion v
Source for metric set screws?

Thread Modes
Source for metric set screws?
TomG Offline
Alt. Whipping Boy
*******
Posts: 3,798
Threads: 184
Joined: Jun 2012
Location: Farmington Hills, Michigan
#2
02-03-2014, 12:27 AM
Willie,

No clue on the screws but believe it or not, M4 x .75 dies are available. Just run some M4 x .7 screws through one. The difference in pitch is only about 2 TPI.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:


Messages In This Thread
Source for metric set screws? - by Highpower - 02-02-2014, 04:48 PM
RE: Source for metric set screws? - by TomG - 02-03-2014, 12:27 AM
RE: Source for metric set screws? - by Highpower - 02-03-2014, 01:38 AM
RE: Source for metric set screws? - by Mayhem - 02-03-2014, 06:19 AM
RE: Source for metric set screws? - by Highpower - 02-03-2014, 05:04 PM
RE: Source for metric set screws? - by PixMan - 02-03-2014, 11:18 AM
RE: Source for metric set screws? - by unioncreek - 02-03-2014, 04:19 PM
RE: Source for metric set screws? - by EdK - 02-03-2014, 05:07 PM
RE: Source for metric set screws? - by Highpower - 02-03-2014, 05:46 PM
RE: Source for metric set screws? - by Arbalest - 02-03-2014, 05:44 PM
RE: Source for metric set screws? - by PixMan - 02-05-2014, 07:14 AM
RE: Source for metric set screws? - by awemawson - 02-05-2014, 07:56 AM
RE: Source for metric set screws? - by Mayhem - 02-05-2014, 08:01 AM
RE: Source for metric set screws? - by Highpower - 02-05-2014, 02:11 PM
RE: Source for metric set screws? - by stevec - 02-06-2014, 06:53 AM



Users browsing this thread: 3 Guest(s)