|
1-2-3 blocks
|
02-01-2014, 07:01 PM
Curiosity got the best of me so I went and checked the two sets of 1-2-3 blocks I have. The Phase II set has unthreaded holes that almost pass a 3/8" bolt through them but not quite. The no-name set has the minor diameter bolt dimension for the unthreaded holes. I think they are just surface hardened. Would a carbide drill bit work to drill these holes out?
 Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
1-2-3 blocks - by hswaters - 01-31-2014, 05:45 PM
RE: 1-2-3 blocks - by aametalmaster - 01-31-2014, 05:53 PM
RE: 1-2-3 blocks - by TomG - 01-31-2014, 07:10 PM
RE: 1-2-3 blocks - by krv3000 - 01-31-2014, 08:08 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 08:18 PM
RE: 1-2-3 blocks - by arvidj - 01-31-2014, 10:09 PM
RE: 1-2-3 blocks - by hswaters - 01-31-2014, 10:28 PM
RE: 1-2-3 blocks - by stevec - 02-01-2014, 07:40 AM
RE: 1-2-3 blocks - by Arbalest - 02-01-2014, 08:14 AM
RE: 1-2-3 blocks - by chucketn - 02-01-2014, 08:19 AM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:01 PM
RE: 1-2-3 blocks - by PixMan - 02-01-2014, 07:30 PM
RE: 1-2-3 blocks - by EdK - 02-01-2014, 07:37 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:11 AM
RE: 1-2-3 blocks - by Mayhem - 02-01-2014, 11:38 PM
RE: 1-2-3 blocks - by arvidj - 02-02-2014, 09:22 AM
RE: 1-2-3 blocks - by aametalmaster - 02-02-2014, 10:16 AM
RE: 1-2-3 blocks - by TomG - 02-02-2014, 10:52 AM
|
