01-31-2014, 05:45 PM
Thanks guys!
Tom, that looks like a very valuable resource and one that I will need to take some time to digest. The keyseat is indeed 3.15mm. I used my depth gauge (which I calibrated only a few weeks ago) to measure it. This mill was made in either 1969 or 1970, so I wonder if such a standard was in place.
Ken, thanks for doing the legwork in chasing down the material for me. Did we make the post for my QCTP out of that 1117? Also, there is no rush on this. I don't want Donna cursing my name for you not being home. Thanks again for doing this for me - it is greatly appreciated.
Tom, that looks like a very valuable resource and one that I will need to take some time to digest. The keyseat is indeed 3.15mm. I used my depth gauge (which I calibrated only a few weeks ago) to measure it. This mill was made in either 1969 or 1970, so I wonder if such a standard was in place.
Ken, thanks for doing the legwork in chasing down the material for me. Did we make the post for my QCTP out of that 1117? Also, there is no rush on this. I don't want Donna cursing my name for you not being home. Thanks again for doing this for me - it is greatly appreciated.
Hunting American dentists since 2015.