I didn't have a lot of time in the shop over the weekend, so I was looking at some of the projects I have on the go. The burner for my furnace has been put on hold mainly due to the total fire ban we have here.
I decided that I would cut the hole for the blower tube. I have some 2" OD pipe that I am going to use, so I set the burner tube up on the drill press, setting the angle of the table to 45°. It wasn't the easiest set up and I ended up having to make a quick and dirty angle plate. Fortunately I had the material in stock. The rectangular pieces already had holes in them and all I had to do to the triangular pieces was trim them to length.
EDIT: to fix a typo
I decided that I would cut the hole for the blower tube. I have some 2" OD pipe that I am going to use, so I set the burner tube up on the drill press, setting the angle of the table to 45°. It wasn't the easiest set up and I ended up having to make a quick and dirty angle plate. Fortunately I had the material in stock. The rectangular pieces already had holes in them and all I had to do to the triangular pieces was trim them to length.
EDIT: to fix a typo
Hunting American dentists since 2015.