|
Raising equipment
|
 (01-21-2014, 10:36 AM)Mayhem Wrote: ...I really should measure the hight of the hand wheels and figure out how much hight I need to add... Done: x-axis handwheel: - top to ground = 910mm (35.827") - centre to ground = 825mm (32.480") z-axis handwheel: - top to ground = 825mm (32.480") - centre to ground = 670mm (26.378") Ways: - top to ground = 785mm (30.906") I'm 180cm tall (5'11"), so I think 100mm (4") sounds about right.
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Raising equipment - by Mayhem - 01-20-2014, 05:13 AM
RE: Raising equipment - by awemawson - 01-20-2014, 06:20 AM
RE: Raising equipment - by stevec - 01-20-2014, 09:12 AM
RE: Raising equipment - by f350ca - 01-20-2014, 10:53 AM
RE: Raising equipment - by haroldmulder - 01-20-2014, 06:42 PM
RE: Raising equipment - by stevec - 01-21-2014, 08:31 AM
RE: Raising equipment - by Mayhem - 01-21-2014, 10:36 AM
RE: Raising equipment - by Mayhem - 01-23-2014, 06:59 AM
RE: Raising equipment - by PixMan - 01-23-2014, 08:54 PM
RE: Raising equipment - by Mayhem - 01-23-2014, 09:40 PM
RE: Raising equipment - by PixMan - 01-23-2014, 10:49 PM
RE: Raising equipment - by Mayhem - 01-24-2014, 07:31 AM
RE: Raising equipment - by Mayhem - 01-25-2014, 09:59 PM
RE: Raising equipment - by stevec - 01-26-2014, 07:55 AM
|
